Abbott i-STAT Alinity User Manual

Delivery System
The Delivery System item is created to document how oxygen is delivered. Various oxygen delivery
systems have sengs or measurements that should be documented. The sengs and/or measurements
are created as STATNote items. Items must be created and available in the Manage Items secon before
building the Delivery System. See Table below for examples of delivery systems.
Note: All STATNotes items must be available before a Delivery System item can be
created.
Example, the table below shows various delivery systems and the corresponding STATNotes items and
modes.
Table 3–3: Delivery System table
Delivery System STATNotes Items and Modes
Vent Mode (custom-built mode)
Room Air None
BNC LPM
FIO2
iNO
VenMask FIO2
CPAP FIO2
CPAP
LPM
In the table above, BNC delivery system requires 3 STATNotes items. To check whether these STATNotes
items exist: Click Manage and Assemble Proles > STATNotes > Manage Items
The screen displays all exisng items. If all of the STATNotes items needed for delivery system BNC are
included in the list, this means that the delivery system item can be built. It is also important to note,
when checking the STATNotes list for an item, the item may exist under the "APOC" name. For example,
if you are searching the list for the Set Rate item, it may be listed as APOC set rate.
If any of the STATNotes items do not exist, create them.
When creang a Delivery System item, the following steps will be completed:
Item Name Required. Specify a name that is from 1 to 20 characters long and:
• does not begin with the characters APOC (in upper or lower
case)
• is a unique name within this healthcare organizaon.
222
i-STAT Alinity — System Operaons Manual Art: 746300-01 Rev. N Rev. Date: 02-Nov-2022

Abbott i-STAT Alinity Specifications

General

Brand	Abbott
Model	i-STAT Alinity
Category	Medical Equipment
Language	English