ACU-RITE MILLPWR G2 - Running the Program

ACU-RITE MILLPWR
G2
151
7.1 Demonstration Program
Running the program
 The first step in running a new program is to establish datum.
Remember to chose the center of the bolt circle as datum.
 Place the workpiece into a vise.
 Place the first tool of the program into the spindle.
 From the DRO screen, press the Move Table soft key. Using the
arrows, and soft keys, position the workpiece under the tool where
the center of the bolt circle’s datum is to be.
 After the table has been properly positioned, press the Exit soft key
to return to the DRO screen.
 Touch the tool to the top surface of your workpiece.
 Press the Datum soft key.
 Press the X = 0, Y = 0 and Z = 0 soft keys to establish the current
tool position as datum.
 Press the DOWN ARROW key.
 Set the Z retract position 1” above the workpiece.
 Press the USE key.