ACU-RITE MILLPWR G2 - Bottom Finishing

ACU-RITE MILLPWR
G2
199
8.2 Additional Milling Functions
Bottom Finishing
The Bottom Finish removes the material from the bottom of the
custom pocket.
The Bottom Finish step must be programmed after the rough milling
cycle(s) and before side finishing. If no side finish step is programmed
after the Bottom Finish step, the side finish operation is performed
using the parameter settings in the custom pocket step.
To program a bottom finishing operation:
 From the PGM screen, place the cursor immediately below the last
rough mill step.
 If necessary, program a Set Tool step with the finishing tool's size
and parameter settings.
 Press the Program Steps soft key.
 Select Bottom Finish in the popup menu.
 Enter the Z axis feed rate.
 Enter the table's finish feed rate.
 For Direction, press either the CW or CCW soft key. The direction is
applied specifically to the bottom finish operation.
 Press the USE key.