ACU-RITE MILLPWR G2 - New Functions of Software

ACU-RITE MILLPWR
G2
7
Manual Information
New functions of software
751005-01-01
 Zero Incremental was added to Chapter 2.2.
751005-02-00
 Geometry/RPM Calculator functions added to Chapter 9.2.
 Support for Auxiliary Machine Interface (AMI) added to Chapter 8.2
 Basic editing of g-code programs added to Chapter 6.2
 Tool step supports plunge angle, added to Chapter 4.1.
 Pockets can be ramped into at an angle or plunged into.
751005-03-00
 Pilot Drilling has been added to programing functions in Chapter 8.2.
 Display resolution can be selected for metric and inch; see
Chapter 10.1
 Drill markers corresponding to the tool size are now shown in 2D
and 3D line views for MILLPWR
G2
programs; see Chapter 5.1.
 G-code programs now support the Block Form feature;
see Chapter 6.2.
 Reference points are now shown graphically; see Chapter 5.1.
751005-04-00
 Advanced custom pocket machining has been added; see
Chapter 8.2.
 Step Form Validation has been added; see page 102.
 Radial Slot Cycle has been added; see Chapter 8.1.
 Parameter for reduced feedrate on full pocket cuts has been added
to Job Setup; see Chapter 10.1.