ACU-RITE MILLPWR G2 - DRO Manual Data Input

52 3 DRO Mode and Calculator
3.1 DRO Manual Data Input
3.1 DRO Manual Data Input
Overview
The MILLPWR
G2
is in either DRO mode or PGM mode. DRO mode allows
data input for short one step machining operations. Manual operation,
single step operation, and single commands can be entered. DRO mode
also allows the running of programs; See "DRO operations" on page
60.
The following describes the concepts, and formats used with the
MILLPWR
G2
which are being introduced in this chapter.
 DRO Screen
 Status Bar Display
 Move Table
 Milling Functions
 Zeroing an Axis
 Teach Position
 Electronic Edge Finder
 Skewing
 Milling Function Keys
 DRO Operations
 DRO Mill Cycles
 Calculator