224 10 Setup
10.1 Setup
10.1 Setup
Overview
The MILLPWR
G2
has a set of parameters that can be setup as default
values. Some of these values can be over-ridden per the program step
dialogue, while others remain in affect until changed in the Job Setup
dialogue.
Setup
Press the SETUP key to access the Job Setup dialogue.
In the Job Setup dialogue the Installation Setup
dialogue can be accessed by pressing the Install
Setup soft key.
Job setup
Job setup parameters can be changed to accommodate specific
machining requirements for each job.
Installation setup
Press the Install Setup soft key to access the
Installation Setup dialogue.
Installation setup parameters are established during the initial
installation and typically are not changed. The installation setup
parameters are protected by a passcode. These parameters are
described within the MILLPWR
G2
Installation Manual.
Tool table
Press the Tool Table soft key to access the tool table.
The tool table is briefly discussed in this chapter. In the table, up to 99
tools can be entered and used in any program that would required that
tool. See chapter 4.1 Tool Table on page 68 for a complete description
about using the Tool Table.
Message log
Press the Message Log soft key to access the message
log display.
The message log records all errors, and retains up to the last 128
messages in the MILLPWR
G2
until it is deleted. A message in the log
can be highlighted, and an explanation of the message can be
displayed by pressing the Info soft key.
The message log entries may also be cleared from the
DRO or PGM screen by pressing the 0 numeric key.
To Next Page
