ACU-RITE MILLPWR G2 - Changed Functions of Software

8
Manual Information
Changed functions of software
751005-01-01
 Blend/Chamfer information input (see page 164) has been
redefined.
 Preset Moves information input (see page 49) has been redefined.
 Display:Peck\Pass (see page 227) has a note added that the limit of
pecks or passes is 9999.
751005-01-02
 The off-line software described (see page 234) now requires the
purchase of a USB Protection Module for operation.
 Custom Pocket: The tool path for custom pockets and islands,
described (see page 194) has changed to use the programmed
cutting convention.
751005-01-03
 A message box warning that the table limits are not established prior
to homing has been added (see page 25).
751005-01-04
 Part Graphics: The show tool path and show step number options
were removed from the graphics view (see page 80).
 Probing examples were added (see page 105).
751005-02-00
 Rectangular milling functions can now be established from its
center position (see page 169).
 Max feedrate override can now be up to 200%, see page 225.
 Support for angles in DMS (see page 46).
 Change steps allows changing of drill types (see page 192).
 Tool steps can now be programed using a tool number (see page
71).
 Program functions enhancements (see page 80).
 Explode step function on Engrave Arc and Engrave Line steps (see
page 190).
 Improved graphics performance (see page 79).