Version 16.10 AF-6600 AF-5000 Series Install Manual 19
11. Configure the EFIS Advanced SV-Network
SCAN for SV-Network devices on the Pilot PFD screen in the aircraft after connecting any new device.
Press UPDT if any detected devices need updating.
12. Configure Admin Settings for ADAHRS, Airdata, Engine on each screen
Configure the IP Address for each screen in the aircraft. The PFD EFIS Screen must have IP Address
175. Two EFIS Screens in the same aircraft must not have the same IP Address.
13. Configure Serial Ports and GPS/NAV data sources on each screen
Configure each serial port on each EFIS screen for the type of data it will be sending and receiving. The
three GPS/NAV data sources on all EFIS screens in the aircraft must be pointed to the same device.
You should never point a GPS/NAV data source to the RS-232 Aviation serial port connected to a GPS
Navigator (IFD440, IFD540, GTN650, GTN750)
14. Select correct engine sensor part number for each engine sensor on the PFD.
The correct part number for each engine sensor should be selected on the PFD EFIS Screen. You
cannot select the sensor part number on an EFIS screen that is not the SV-Network “Master”.
15. Calibrate the Fuel Tanks sensors on the PFD EFIS.
You should calibrate the fuel tanks on the PFD EFIS Screen with all EFIS screens powered up.
16. Calibrate the Trim and Flap sensors on PFD EFIS.
17. Configure the Aircraft V Speeds on each screen
This will need to be configured on each EFIS Screen in the Aircraft.
18. Configure each Engine Gauges Red-Yellow-Green ranges on each Screen.
This will need to be configured on each EFIS Screen in the Aircraft.
19. Configure the Fuel Tank size and Red-Yellow-Green ranges on each Screen.
This will need to be configured on each EFIS Screen in the Aircraft.
20. Configure Weight and Balance data on each screen.
This will need to be configured on each EFIS Screen in the Aircraft.
21. Configure Check List data on each screen.
This will need to be configured on each EFIS Screen in the Aircraft.
22. Configure the Inputs on each Screen.
Each EFIS Screen has three unique inputs that will need to be configured.
23. Configure Radio Settings on each screen
The Radio type will need to be configured on each EFIS Screen in the Aircraft that you want to be able
to tune the Radio on.
24. Configure Transponder Settings on each screen
The Transponder type will need to be configured on each EFIS Screen in the Aircraft that you want to
be able to tune the Transponder on.
25. Verify Correct Airdata settings and plumbing with a Pitot/Static test before the first
flight.
You should have a Pitot-Static and Transponder test performed on the aircraft to verify that
everything is working correctly before the aircraft is flown for the first time.
To Next Page
Loading...