Agilent Technologies 93000 SOC Series - Page 449

Lesson 2 – Creating a Test Method
449
Testsuite Dialog
5
Then, place the cursor in the test method entry box at the bottom
of the testsuite dialog, and click the Select button. A selection box
dialog shown in the following figure appears.
Selection Box Dialog
6
Select the desired class from the list in the selection box dialog.
Highlight the desired method in the Method window in the
selection dialog. For names combined with ‘’ (space), the selected
class and method will be displayed in the test method entry box.
4. Click Select button.1. Activate this button.
3. Place cursor in testmethod entry box.
2. Fill these areas.
Set testsuite name, vector label,
and primary set numbers of various data
Cursor