Lesson 3 – TIA Test Method Programming and Test Execution
502
Executing the Test
To perform the measurement, the test must be executed. The
execution starts the digital sequencer (for analog modules other
than the TIA also the analog sequencer) and stops when the
sequencer(s) stop. The test is executed with the command:
Executing the Test
Retrieving Measured and Calculated Results
After the test execution, all measured data and also the results
calculated from this data are stored in the local memory of the
TIA. The TIA can calculated the following values from the
measured data:
• Mean (averaged value)
• Jitter RMS (standard deviation)
• Maximum value
• Minimum value
To evaluate this data, it must be read from the TIA memory.
To Next Page
Loading...
