Alcatel-Lucent OmniSwitch 6800 Series - Enabling and Disabling Management TLV; Enabling and Disabling 802.1 TLV

Configuring 802.1AB Configuring 802.1AB
page 13-8 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Enabling and Disabling Management TLV
The lldp tlv management command is used to control per port management TLVs transmission in the
LLDPDUs on a specific port, a slot, or all ports on a switch. When enabled, the LLDPDU administrative
status must be in the transmit state.
To enable the management TLV LLDPDU transmission on a switch, enter the lldp tlv management
command, as shown:
-> lldp chassis tlv management port-description enable
To enable the management TLV on port 3 of slot 2, enter the following command at the CLI prompt:
-> lldp 2/3 tlv management system-capabilities enable
To disable the management TLV on a switch, enter the lldp tlv management command, as shown:
-> lldp chassis tlv management port-description disable
To disable management TLV on port 3 of slot 2, enter the following command at the CLI prompt:
-> lldp 2/3 tlv management system-capabilities disable
Enabling and Disabling 802.1 TLV
The lldp tlv dot1 command is used to control per port 802.1 TLVs transmission in the LLDPDUs on a
specific port, a slot, or all ports on a switch. When enabled, the LLDPDU administrative status must be in
the transmit state.
To enable the 802.1 TLV LLDPDU transmission on a switch, enter the lldp tlv dot1 command, as shown:
-> lldp chassis tlv dot1 port-vlan enable
To enable the 802.1 TLV on port 1 of slot 5, enter the following command at the CLI prompt:
-> lldp 5/1 tlv dot1 vlan-name enable
To disable the 802.1 TLV on a switch, enter the lldp tlv dot1 command, as shown:
-> lldp chassis tlv dot1 port-vlan disable
To disable 802.1 TLV on port 2 of slot 5, enter the following command at the CLI prompt:
-> lldp 5/2 tlv dot1 vlan-name disable