Alcatel-Lucent OmniSwitch 6800 Series - ACLMAN Modes and Commands; Privileged Exec Mode Commands

ACLMAN Modes and Commands Using ACL Manager
page 28-8 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
ACLMAN Modes and Commands
The ACLMAN interactive shell supports a limited subset of common industry ACL syntax necessary to
create Alcatel-Lucent ACLs. In line with industry command line interfaces, the ACLMAN shell provides
the following command modes:
• Privileged Exec Mode
• Global Configuration Mode
• Interface Configuration Mode
• Access List Configuration Mode
• Time Range Configuration Mode
Privileged Exec Mode Commands
Upon entering the interactive shell the Privileged Exec mode is automatically active. At this point the
following commands are available:
The Privileged Exec mode also includes the following commands that are specific to the Alcatel-Lucent
implementation of ACLMAN:
Command Description
clear access-list counters [name | number] Resets the statistics counters to zero for the specified ACL.
If an ACL name or number is not entered, then the counters
for all ACLs are reset.
configure replace Clears the entire running configuration out of memory and
replaces it with the contents of the aclman.cfg file.
configure terminal Accesses the Global Configuration command mode. Com-
mand prompt changes to Aclman (config)#
exit Closes the ACLMAN interactive shell and returns to the
Alcatel-Lucent CLI. The ACLMAN shell is no longer
active.
show access-lists [name | number] Displays the contents of the specified ACLs. If an ACL
name or number is not entered, all ACLs are shown.
show ip interface [type slot/port] Displays ACLs associated with the specified interface. If an
interface is not specified, all configured interfaces are
shown.
show running-config Displays the entire ACLMAN configuration, not just the
ACL configuration.
show time-range [name] Displays the specified time range. If no name is specified,
all time ranges are shown.
Command Description
import filename Imports ACL syntax from the specified text file.
logging-rate seconds Configures the logging rate time interval. The range is 0
to 3600 seconds. The default value is 30 seconds.