Displaying Source Learning Information Managing Source Learning
page 1-10 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Displaying Source Learning Information
To display MAC Address Table entries, statistics, and aging time values, use the show commands listed
below:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show mac-address-table and show mac-address-table
aging-time commands is also given in “Sample MAC Address Table Configuration” on page 1-2.
show mac-address-table Displays a list of all MAC addresses known to the MAC address
table, including static MAC addresses.
show mac-address-table static-
multicast
Displays a list of all static multicast MAC addresses known to the
MAC address table. Note that only static multicast addresses
assigned to ports that are up and enabled are displayed with this
command.
show mac-address-table count Displays a count of the different types of MAC addresses (learned,
permanent, reset, and timeout). Also includes a total count of all
addresses known to the MAC address table.
show mac-address-table aging-time Displays the current MAC address aging timer value by switch or
VLAN.
show source-learning chassis-
distributed
Displays the current status of the distributed MAC source learning
mode.
To Next Page
Loading...
