Configuring UDLD Configuring UDLD
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 38-7
Configuring mode
To configure the operational mode, use the udld mode command as shown:
-> udld mode aggressive
For example, to configure the mode for port 4 on slot 2, enter:
-> udld port 2/4 mode aggressive
To configure the mode for multiple ports, specify a range of ports. For example:
-> udld port 2/7-18 mode normal
Note. The Normal mode is the default operational mode of UDLD.
Configuring probe-timer
To configure the probe-message advertisement timer, use the udld probe-timer command as shown:
-> udld probe-timer 20
For example, to configure the probe-timer for port 3 on slot 6, enter:
-> udld port 6/3 probe-timer 18
To configure the probe-timer for multiple ports, specify a range of ports. For example:
-> udld port 1/8-21 probe-timer 18
Use the no form of this command to reset the timer. For example, the following command resets the timer
for port 4 of slot 6:
-> no udld port 6/4 probe-timer
The following command resets the timer for multiple ports:
-> no udld port 1/8-21 probe-timer
Note that when a timer is reset, the default value of 15 seconds is set.
Configuring echo-wait-timer
To configure the echo-based detection timer, use the udld echo-wait-timer command as shown:
-> udld echo-wait-timer 9
For example, to configure the echo-wait-timer for port 5 on slot 6, enter:
-> udld port 6/5 echo-wait-timer 12
To configure the echo-wait-timer for multiple ports, specify a range of ports. For example:
-> udld port 1/8-21 echo-wait-timer 9
Use the no form of this command to reset the timer. For example, the following command resets the timer
for port 6 of slot 4:
To Next Page
Loading...
