Diagnosing Switch Problems sFlow Overview
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 35-7
sFlow Overview
The following sections detail the specifications, defaults, and quick set up steps for the sFlow feature.
Detailed procedures are found in “sFlow” on page 35-29.
Note. sFlow is only supported on the OmniSwitch 6850 and OmniSwitch 9000 for this release.
sFlow Specifications
sFlow Defaults
The following table shows sFlow default values:
sFlow Defaults
RFCs Supported 3176 - sFlow
Management Information Base
Sampling Sampling rate of one (1) counts all packets and 0
(zero) disables sampling.
Agent IP Address As it need to send a fixed IP address in the data-
gram, loopback0 IP address is used.
Parameter Description CLI Command Default Value/Comments
Receiver Name sflow receiver Empty
Timeout Value sflow receiver 0 seconds
IP Address sflow receiver 32 bit address (IPv4)
Data File Size sflow receiver 1400 Bytes
Version Number sflow receiver 5
Destination Port sflow receiver 6343
Receiver Index sflow sampler 0
Packet Sampling Rate sflow sampler 0
Sampled Packet Size sflow sampler 128 Bytes
Receiver Index sflow poller 0
Interval Value sflow poller 0 seconds
To Next Page
Loading...
