Alcatel-Lucent OmniSwitch 6800 Series - Chapter 4 Configuring Learned Port Security; Learned Port Security Specifications; Learned Port Security Defaults

Learned Port Security Specifications Configuring Learned Port Security
page 3-2 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Learned Port Security Specifications
Learned Port Security Defaults
RFCs supported Not applicable at this time.
IEEE Standards supported Not applicable at this time.
Ports eligible for Learned Port Security Ethernet and gigabit Ethernet ports (fixed, mobile,
802.1Q tagged, and authenticated ports).
Ports not eligible for Learned Port Security Link aggregate ports.
802.1Q (trunked) link aggregate ports.
Minimum number of learned MAC addresses
allowed per port
1
Maximum number of learned MAC addresses
allowed per port
100
Maximum number of configurable MAC address
ranges per LPS port
1
Maximum number of learned MAC addresses per
switch
16K
Parameter Description Command Default
LPS status for a port. port-security disabled
Number of learned MAC addresses
allowed on an LPS port.
port-security maximum 1
Maximum number of filtered MAC
addresses that the LPS port can
learn.
port-security max-filtering 5
Source learning time limit. port-security shutdown disabled
Configured MAC addresses per LPS
port.
port-security mac none
MAC address range per LPS port. port-security mac-range 00:00:00:00:00:00–
ff:ff:ff:ff:ff:ff
LPS port violation mode. port-security violation restrict
Number of bridged MAC addresses
learned before a trap is sent.
port-security learn-trap-
threshold
5