Alcatel-Lucent OmniSwitch 6800 Series - Verifying the VLAN Stacking Configuration

Verifying the VLAN Stacking Configuration Configuring VLAN Stacking
page 6-36 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Verifying the VLAN Stacking Configuration
You can use CLI show commands to display the current configuration and statistics of service-based
VLAN Stacking on a switch. These commands include the following:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show ethernet-service command is also given in “Quick
Steps for Configuring Service-Based VLAN Stacking” on page 6-12.
You can use CLI show commands to display the current configuration and statistics of port-based VLAN
Stacking on a switch. These commands include the following:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show vlan svlan is also provided below.
To display the status and configuration of all SVLANs on a switch enter:
-> show vlan svlan
A screen similar to the following is displayed:
svlan priority traffic name
+-------+----------+----------+-------------------------+
1001 mapped customer Customer ABC
1002 5 customer Customer XYZ
To display the status and configuration of a single SVLAN enter:
-> show vlan svlan 1001
A screen similar to the following is displayed:
Name : Customer ABC
Priority : mapped
TrafficType : customer
show ethernet-service mode Displays the active VLAN Stacking mode for the switch.
show ethernet-service vlan Displays the SVLAN configuration for the switch.
show ethernet-service Displays the VLAN Stacking service configuration for the switch.
show ethernet-service sap Displays the VLAN Stacking service access point (SAP) configura-
tion for the switch.
show ethernet-service port Displays configuration information for VLAN Stacking ports.
show ethernet-service nni Displays configuration information for NNI port parameters.
show ethernet-service uni Displays profile associations for UNI ports.
show ethernet-service uni-profile Displays UNI profile attribute values.
show ethernet-service sap-profile Displays SAP profile attribute values.
show vlan svlan Displays the SVLAN configuration for the switch.
show vlan svlan port-config Displays the VLAN Stacking port/link aggregate configuration for the
switch.
show vlan svlan port-binding Displays the configured SVLAN-port associations.