Port Monitoring Diagnosing Switch Problems
page 35-28 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Displaying Port Monitoring Status and Data
A summary of the show commands used for displaying port monitoring status and port monitoring data is
given here:
For example, to display port monitoring data, use the show port monitoring file command as shown
below:
-> show port monitoring file
Destination | Source | Type | Data
-------------------------------------------------------------------------------
01:80:C2:00:00:00 | 00:20:DA:8F:92:C6 | BPDU | 00:26:42:42:03:00:00:00:00:00
00:20:DA:C7:2D:D6 | 08:00:20:95:F3:89 | UDP | 08:00:45:00:00:6B:FE:4A:40:00
00:20:DA:A3:89:F6 | 08:00:20:95:F3:89 | UDP | 08:00:45:00:00:6B:CF:89:40:00
00:20:DA:BF:5B:76 | 08:00:20:95:F3:89 | UDP | 08:00:45:00:00:6B:CF:85:40:00
00:20:DA:A3:89:F6 | 08:00:20:95:F3:89 | UDP | 08:00:45:00:00:6B:CF:8A:40:00
00:20:DA:BF:5B:76 | 08:00:20:95:F3:89 | UDP | 08:00:45:00:00:6B:CF:86:40:00
00:20:DA:A3:89:F6 | 08:00:20:95:F3:89 | UDP | 08:00:45:00:00:6B:CF:8B:40:00
01:80:C2:00:00:00 | 00:20:DA:8F:92:C6 | BPDU | 00:26:42:42:03:00:00:00:00:00
00:20:DA:BF:5B:76 | 08:00:20:95:F3:89 | UDP | 08:00:45:00:00:6B:CF:87:40:00
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
show port monitoring status Displays port monitoring status.
show port monitoring file Displays port monitoring data.
To Next Page
Loading...
