Configuring IP Verifying the IP Configuration
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 18-35
Verifying the IP Configuration
A summary of the show commands used for verifying the IP configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show ip interface Displays the usability status of interfaces configured for IP.
show ip route Displays the IP Forwarding table.
show ip route-pref Displays the configured route preference of a router.
show ip router database Displays a list of all routes (static and dynamic) that exist in the IP
router database.
show ip config Displays IP configuration parameters.
show ip protocols Displays switch routing protocol information and status.
show ip service Displays the current status of TCP/UDP service ports. Includes service
name and well-known port number.
show arp Displays the ARP table.
show arp filter Displays the ARP filter configuration for the switch (OmniSwitch
9000 only).
show icmp control This command allows the viewing of the ICMP control settings.
show ip dos config Displays the configuration parameters of the DoS scan for the switch.
show ip dos statistics Displays the statistics on detected port scans for the switch.
To Next Page
Loading...
