Alcatel-Lucent OmniSwitch 6800 Series - Setting the Statistics Interval; Returning the Global Configuration to Defaults; Verifying Global Settings

Configuring QoS Configuring Global QoS Parameters
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 30-23
Setting the Statistics Interval
To change how often the switch polls the network interfaces for QoS statistics, use the qos stats interval
command with the desired interval time in seconds. The default is 60 seconds. For example:
-> qos stats interval 30
Statistics are displayed through the show qos statistics command. For more information about this
command, see the OmniSwitch CLI Reference Guide.
Returning the Global Configuration to Defaults
To return the global QoS configuration to its default settings, use the qos reset command. The defaults
will then be active on the switch. For a list of global defaults, see “QoS Defaults” on page 30-10.
Note. The qos reset command only affects the global configuration. It does not affect any policy configu-
ration.
Verifying Global Settings
To display information about the global configuration, use the following show commands:
For more information about the syntax and displays of these commands, see the OmniSwitch CLI Refer-
ence Guide.
show qos config Displays global information about the QoS configuration.
show qos statistics Displays statistics about QoS events.