Configuring RDP Verifying the RDP Configuration
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 21-11
Verifying the RDP Configuration
To display information about the RDP configuration on the switch, use the show commands listed below:
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. An example of the output for the show ip router-discovery and show ip router-discovery
interface commands is also given in “Quick Steps for Configuring RDP” on page 21-3.
show ip router-discovery Displays the current operational status of RDP on the switch. Also
includes the number of advertisement packets transmitted and the num-
ber of solicitation packets received by all RDP interfaces on the switch.
show ip router-
discovery interface
Displays the current RDP status, related parameter values, and RDP
traffic statistics for one or more switch router RDP interfaces.
To Next Page
Loading...
