Diagnosing Switch Problems sFlow
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 35-33
Agent Version = 1.3; Alcatel-Lucent; 6.1.1
Agent IP = 127.0.0.1
Note. For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
Deleting a sFlow Session
To delete a sFlow receiver session, use the release form at the end of the sflow receiver command by
entering sflow receiver, followed by the receiver index and release. For example, to delete sFlow receiver
session 6, enter:
-> sflow receiver 6 release
To delete a sFlow sampler session, use the no form of the sflow sampler command by entering no sflow
sampler, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the
port number of the port, enter:
-> no sflow sampler 1 2/3
To delete a sFlow poller session, use the no form of the sflow poller command by entering no sflow
poller, followed by the instance ID number, the slot number of the port to delete, a slash (/), and the port
number of the port, enter:
-> no sflow poller 3 1/1
To Next Page
Loading...
