Configuring VRRP VRRP Specifications
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 23-3
VRRP Specifications
VRRP Defaults
The following table lists the defaults for VRRP configuration through the vrrp command and the relevant
command keywords:
The following table lists the defaults for VRRP configuration using the VRRP collective management
features and the relevant command:
RFCs Supported RFC 3768–Virtual Router Redundancy Protocol
RFC 2787–Definitions of Managed Objects for the Virtual
Router Redundancy Protocol
Compatible with HSRP? No
Maximum number of VRRPv2 and VRRPv3
virtual routers combined
255 per switch
Maximum number of IP addresses 255 per virtual router
Description Keyword Default
Virtual router enabled or dis-
abled
enable | disable | on | off Virtual routers are disabled (off)
Priority priority 100
Preempt mode preempt | no preempt Preempt mode is enabled
Advertising interval advertising interval 1 second
Default advertising interval for
all the virtual routers on the
switch.
vrrp interval 1 second
Default priority value for all the
virtual routers on the switch.
vrrp priority 100
Default preempt mode for all the
virtual routers on the switch.
vrrp preempt preempt
Parameter value that is to be set
and/or override with the new
default value in all the virtual
routers on the switch.
vrrp set all
Default advertising interval for
all the virtual routers in the
group.
vrrp group 1
Default priority value for all the
virtual routers in the group.
vrrp group 100
Default preempt mode for all the
virtual routers in the group.
vrrp group preempt
To Next Page
Loading...
