Alcatel-Lucent OmniSwitch 6800 Series - DHCP Relay Defaults

Configuring DHCP Relay DHCP Relay Defaults
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 22-3
DHCP Relay Defaults
The following table describes the default values of the DHCP Relay parameters:
Parameter Description Command Default Value/Comments
Default UDP service ip udp relay BOOTP/DHCP
Forward delay time value for DHCP Relay ip helper forward delay 3 seconds
Maximum number of hops ip helper maximum hops 4 hops
Packet forwarding option ip helper standard
ip helper avlan only
ip helper per-vlan only
Standard
Automatic switch IP configuration for
default VLAN 1
ip helper boot-up Disabled
Automatic switch IP configuration packet
type (BootP or DHCP)
ip helper boot-up enable BootP
Relay Agent Information Option ip helper agent-informa-
tion
Disabled
Switch-level DHCP Snooping ip helper dhcp-snooping Disabled
VLAN-level DHCP Snooping ip helper dhcp-snooping
vlan
Disabled