Configuring QoS QoS Defaults
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 30-11
QoS Port Defaults
Use the qos port reset command to reset port settings to the defaults.
Policy Rule Defaults
The following are defaults for the policy rule command:
Description Command/keyword Default
The default 802.1p value inserted
into packets received on
untrusted ports.
qos port default 802.1p 0
The default DSCP value inserted
into packets received on
untrusted ports.
qos port default dscp 0
Whether the port uses strict prior-
ity or weighted fair queuing.
qos port servicing mode strict priority queuing
The default minimum/maximum
bandwidth for each of the eight
CoS queues per port.
(Not supported on the
OmniSwitch 6800.)
qos port q minbw maxbw minimum = best effort
maximum = port bandwidth
Whether the port is trusted or
untrusted
qos port trusted 802.1Q and mobile ports are
always trusted; other ports are
untrusted
The maximum egress bandwidth qos port maximum egress-band-
width
port bandwidth
The maximum ingress bandwidth qos port maximum ingress-band-
width
port bandwidth
Description Keyword Default
Policy rule enabled or disabled enable | disable enabled
Determines the order in which
rules are searched
precedence 0
Whether the rule is saved to flash
immediately
save enabled
Whether messages about flows
that match the rule are logged.
log no
How often to check for matching
flow messages.
log interval 60 seconds
Whether to count bytes or pack-
ets that match the rule.
(Only packets are counted on the
OmniSwitch 6800.)
count packets are counted
To Next Page
Loading...
