Alcatel-Lucent OmniSwitch 6800 Series - Verifying 802.1 Q Configuration

Verifying 802.1Q Configuration Configuring 802.1Q
page 15-10 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
The following steps apply to Stack 3. They will attach ports 4/1 and 4/2 as link aggregation group 5 to
VLAN 3.
1 Configure static link aggregation group 5 by entering the following:
-> static linkagg 5 size 2
2 Assign ports 4/1 and 4/2 to static link aggregation group 5 by entering the following two commands:
-> static agg 4/1 agg num 5
-> static agg 4/2 agg num 5
3 Create VLAN 3 by entering the following:
-> vlan 3
4 Configure 802.1Q tagging with a tagging ID of 3 on static link aggregation group 5 (on VLAN 3) by
entering the following:
-> vlan 3 802.1q 5
5 Check the configuration by using the show 802.1q command, as follows:
-> show 802.1q 5
Tagged VLANS Internal Description
-------------+-------------------------------------------------+
3 TAG AGGREGATE 5 VLAN 3
Verifying 802.1Q Configuration
To display information about the ports configured to handle tagging, use the following show command:
For more information about the resulting display, see Chapter 14, “802.1Q Commands,” in the
OmniSwitch CLI Reference Guide.
show 802.1q Displays 802.1Q tagging information for a single port or a link aggrega-
tion group.