Alcatel-Lucent OmniSwitch 6800 Series - Static Link Aggregation Specifications; Static Link Aggregation Default Values

Static Link Aggregation Specifications Configuring Static Link Aggregation
page 16-2 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Static Link Aggregation Specifications
The table below lists specifications for static groups.
Static Link Aggregation Default Values
The table below lists default values and the commands to modify them for static aggregate groups.
Maximum number of link aggregation groups 32 (per switch or a stack of switches)
Number of links per group supported 2, 4, or 8 (per switch or a stack of switches)
Range for optional group name 1 to 255 characters
CLI Command Prefix Recognition All static link aggregation configuration commands
support prefix recognition. (Static link aggregation
show commands do not support prefix recognition.)
See the “Using the CLI” chapter in the OmniSwitch
6800/6850/9000 Switch Management Guide for more
information.
Parameter Description Command Default Value/Comments
Administrative State static linkagg admin state enabled
Group Name static linkagg name No name configured