Alcatel-Lucent OmniSwitch 6800 Series - Non-Combo Port Defaults; Combo Ethernet Port Defaults

Configuring Ethernet Ports Non-Combo Port Defaults
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 37-3
Non-Combo Port Defaults
The following table shows non-combo port default values:
Combo Ethernet Port Defaults
The following table shows combo Ethernet port default values for OmniSwitch 6800 Series switches only:
Parameter Description Command Default Value/Comments
Interface Line Speed interfaces speed Auto (copper ports)
100 Mbps (fiber ports)
1 Gbps (GNI ports)
10 Gbps (XNI ports)
Duplex Mode interfaces duplex Auto (copper ports)/Full (fiber,
GNI and XNI ports)
Autonegotiation interfaces autoneg Enable for all copper ports;
Disable for all fiber ports
Crossover interfaces crossover Auto for all copper ports;
MDI for all fiber ports (not config-
urable on fiber ports)
Parameter Description Command Default Value/Comments
Preferred fiber
Forced fiber
Preferred copper
Forced copper
interfaces hybrid
preferred-fiber
interfaces hybrid
preferred-copper
interfaces hybrid forced-
fiber
interfaces hybrid forced-
copper
Preferred fiber
Flow (pause) interfaces hybrid speed Disabled
Interface Line Speed interfaces hybrid speed Auto
Duplex Mode interfaces hybrid duplex Auto
Autonegotiation interfaces hybrid
autoneg
Enable
Crossover interfaces hybrid
crossover
Auto for all copper ports