Verifying the IPv6 Configuration Configuring IPv6
page 19-24 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Verifying the IPv6 Configuration
A summary of the show commands used for verifying the IPv6 configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show ipv6 rip Displays the RIPng status and general configuration parameters.
show ipv6 redist Displays the route map redistribution configuration.
show ipv6 interface Displays the status and configuration of IPv6 interfaces.
show ipv6 tunnel Displays IPv6 configured tunnel information and whether the 6to4
tunnel is enabled or not.
show ipv6 routes Displays the IPv6 Forwarding Table.
show ipv6 route-pref Displays the configured route preference of a router.
show ipv6 router database Displays a list of all routes (static and dynamic) that exist in the IPv6
router database.
show ipv6 prefixes Displays IPv6 subnet prefixes used in router advertisements.
show ipv6 hosts Displays the IPv6 Local Host Table.
show ipv6 neighbors Displays the IPv6 Neighbor Table.
show ipv6 traffic Displays statistics for IPv6 traffic.
show ipv6 icmp statistics Displays ICMP6 statistics.
show ipv6 pmtu table Displays the IPv6 Path MTU Table.
show ipv6 tcp ports Displays TCP Over IPv6 Connection Table. Contains information
about existing TCP connections between IPv6 endpoints.
show ipv6 udp ports Displays the UDP Over IPv6 Listener Table. Contains information
about UDP/IPv6 endpoints.
To Next Page
Loading...
