Alcatel-Lucent OmniSwitch 6800 Series - Verifying Network Security Information

Configuring Network Security Configuring Network Security
page 39-8 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Verifying Network Security information
To display information about Network Security configuration settings, use the show commands listed in
the following table:
For more information about the resulting display from these commands, see the OmniSwitch CLI Refer-
ence Guide.
show netsec summary Displays the anomaly check summary.
show netsec traffic Displays the anomaly specific traffic statistics.
show netsec statistics Displays the pattern counts on ports.
show netsec config Displays the current network security configurations.
show netsec operation Displays the network security operational conditions.
show netsec group port Displays the group membership of ports.