Alcatel-Lucent OmniSwitch 6800 Series - RIP Specifications; RIP Defaults

RIP Specifications Configuring RIP
page 20-2 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
RIP Specifications
RIP Defaults
The following table lists the defaults for RIP configuration through the ip rip command.
RFCs Supported RFC 1058–RIP v1
RFC 2453–RIP v2
RFC 1722–RIP v2 Protocol Applicability Statement
RFC 1724–RIP v2 MIB Extension
Maximum Number of RIP Routes 2048
Description Command Default
RIP Status ip rip status disable
RIP Forced Hold-Down Interval ip rip force-holddowntimer 0
RIP Update Interval ip rip update-interval 30 seconds
RIP Invalid Timer ip rip invalid-timer 180 seconds
RIP Garbage Timer ip rip garbage-timer 120 seconds
RIP Hold-Down Timer ip rip holddown-timer 0
RIP Interface Metric ip rip interface metric 1
RIP Interface Send Version ip rip interface send-version v2
RIP Interface Receive Version ip rip interface recv-version both
RIP Host Route ip rip host-route enable
RIP Route Tag ip rip host-route 0