Monitoring Switch Health Diagnosing Switch Problems
page 35-44 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Displaying Health Threshold Limits
The show health threshold command is used to view all current health thresholds on the switch, as well
as individual thresholds for input traffic (RX), output/input traffic (TX/RX), memory usage, CPU usage,
and chassis temperature.
To view all health thresholds, enter the following command:
-> show health threshold
Rx Threshold = 80
TxRx Threshold = 80
Memory Threshold = 80
CPU Threshold = 80
Temperature Threshold = 60
To display a specific health threshold, enter the show health threshold command, followed by the appro-
priate suffix syntax:
• rx
• txrx
• memory
• cpu
• temperature
For example, if you want to view only the health threshold for memory usage, enter the following
command:
-> show health threshold memory
Memory Threshold = 80
Note. For detailed definitions of each of the threshold types, refer to “Configuring Resource and Tempera-
ture Thresholds” on page 35-43, as well as Chapter 41, “Health Monitoring Commands,” in the
OmniSwitch CLI Reference Guide.
To Next Page
Loading...
