Configuring Server Load Balancing Configuring the Server Farm
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 34-13
Configuring a Windows 2000 Server
Follow the steps below to associate a loopback interface on a Windows NT server.
Note. This procedure assumes that your Windows 2000 workstation already has the Microsoft loopback
adapter installed. If this driver has not been installed, please perform the steps in “Adding the Loopback
Adapter Driver to a Windows 2000 Server” on page 34-17 before proceeding.
1 Open the Control Panel window by clicking the Start button and then selecting Settings.
2 Double-click the Network and Dial-up Connections icon in the Control Panel window.
3 Right-click the Microsoft Loopback Adapter icon in the Network and Dial-up Connections
window.
Double click the “Network
and Dial-Up Connections”
icon.
Right-click the “Network
Loopback Adapter” icon.
To Next Page
Loading...
