Configuring QoS Condition and Action Combinations
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 30-9
Condition and Action Combinations
Conditions and actions are combined in policy rules. The CLI prevents you from configuring invalid
condition/action combinations that are never allowed; however, the following table provides a quick refer-
ence for determining which condition/action combinations are not valid. Each row represents a policy
condition or conditions combined with the policy action or actions in the same row.
For more information about policy conditions, see “Condition Combinations” on page 30-6. For more
information about policy actions, see “Action Combinations” on page 30-8.
Policy Condition/Action Combinations
Conditions Actions Supported When?
multicast IP address or network group all actions never, except with disposition action
multicast IPv6 address all actions never, except with disposition and
mirror actions
destination VLAN all policy actions never, except with disposition action
in a multicast rule (a rule that uses
the “multicast” keyword and only
applies to IGMP traffic)
destination slot/port or port group all actions bridging only on OS6850/OS9000
To Next Page
Loading...
