Alcatel-Lucent OmniSwitch 6800 Series - Dynamic Link Aggregation Default Values

Configuring Dynamic Link Aggregation Dynamic Link Aggregation Default Values
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 17-3
Dynamic Link Aggregation Default Values
The table below lists default values for dynamic aggregate groups.
Parameter Description Command Default Value/Comments
Group Administrative State lacp linkagg admin state enabled
Group Name lacp linkagg name No name configured
Group Actor Administrative Key lacp linkagg actor admin key 0
Group Actor System Priority lacp linkagg actor system
priority
0
Group Actor System ID lacp linkagg actor system id 00:00:00:00:00:00
Group Partner System ID lacp linkagg partner system id 00:00:00:00:00:00
Group Partner System Priority lacp linkagg partner system
priority
0
Group Partner Administrative Key lacp linkagg partner admin
key
0
Actor Port Administrative State lacp agg actor admin state active timeout aggregate
Actor Port System ID lacp agg actor system id 00:00:00:00:00:00
Partner Port System Administrative
State
lacp agg partner admin state active timeout aggregate
Partner Port Admin System ID lacp agg partner admin system
id
00:00:00:00:00:00
Partner Port Administrative Key lacp agg partner admin key 0
Partner Port Admin System Priority lacp agg partner admin system
priority
0
Actor Port Priority lacp agg actor port priority 0
Partner Port Administrative Port lacp agg partner admin port 0
Partner Port Priority lacp agg partner admin port
priority
0