Modifying IPMSv6 Parameters Configuring IP Multicast Switching
page 32-34 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
between IP multicast groups.) is disabled on a switch. The following subsections describe how to enable
and disable zapping by using the ipv6 multicast zapping command.
Enabling the MLD Zapping
To enable MLD zapping on the system if no VLAN is specified, use the ipv6 multicast zapping
command as shown below:
-> ipv6 multicast zapping enable
You can also enable MLD zapping on the specified VLAN by entering:
-> ipv6 multicast vlan 2 zapping enable
Disabling the MLD Zapping
To disable MLD zapping on the system if no VLAN is specified, use the ipv6 multicast zapping
command as shown below:
-> ipv6 multicast zapping disable
Or, as an alternative, enter:
-> ipv6 multicast zapping
To restore the MLD zapping to its default setting (i.e., disabled).
You can also disable MLD zapping on the specified VLAN by entering:
-> ipv6 multicast vlan 2 zapping disable
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 zapping
To restore the MLD zapping to its default setting (i.e., disabled).
To Next Page
Loading...
