Configuring ACLs Using ACL Manager
page 28-18 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
Aclman(config)#access-list 102 deny ip host 178.4.25.1 any
Aclman(config)#access-list 102 permit udp any any
Aclman(config)#access-list 102 deny udp host 178.4.25.1 any
To remove a numbered ACL, use the no form of the access-list command. Note that removing a single
entry from a standard ACL is not allowed without deleting the entire ACL. To avoid having to re-enter an
entire ACL each time a change is required, use one of the following configuration methods:
• Create a named ACL instead of a numbered ACL. Removing individual ACL entries is allowed with-
out having to remove and re-enter the entire ACL. See “Configuring Named Standard and Extended
ACLs” on page 28-19 for more information.
• Create the numbered ACL configuration in a text file and use the Privileged Exec Mode import
command to load the text file syntax into the ACLMAN running configuration. Then each time a
change is required for this ACL, simply edit the text file and import the file contents into the
ACLMAN configuration. For more information about importing ACL text files, see “Importing ACL
Text Files” on page 28-21.
To Next Page
Loading...
