Configuring QoS QoS Ports and Queues
OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008 page 30-29
recognize 802.1p bits. A policy condition (Traffic) is then created to classify traffic containing 802.1p bits
set to 4 and destined for port 2 on slot 3. The policy action (SetBits) specifies that the bits will be reset to
7 when the traffic egresses the switch. A policy rule called Rule2 puts the condition and the action
together.
-> qos port 3/2 trusted
-> policy condition Traffic destination port 3/2 802.1p 4
-> policy action SetBits 802.1p 7
-> policy rule Rule2 condition Traffic action SetBits
To activate the configuration, enter the qos apply command. For more information about the qos apply
command, see “Applying the Configuration” on page 30-54.
For actions that set 802.1p bits, note that a limited set of policy conditions are supported. For information
about which conditions may be used with an 802.1p action, see “Condition Combinations” on page 30-6
and “Action Combinations” on page 30-8.
Note. 802.1p mapping may also be set for Layer 3 traffic, which typically has the 802.1p bits set to zero.
To Next Page
Loading...
