IPMSv6 Application Example Configuring IP Multicast Switching
page 32-38 OmniSwitch 6800/6850/9000 Network Configuration Guide March 2008
An example of what these commands look like entered sequentially on the command line:
-> ipv6 multicast status enable
-> ipv6 multicast static-neighbor vlan 5 port 1/5
-> ipv6 multicast static-querier vlan 5 port 1/2
-> ipv6 multicast robustness 7
As an option, you can use the show ipv6 multicast, show ipv6 multicast neighbor, and
show ipv6 multicast querier commands to confirm your settings as shown below:
-> show ipv6 multicast
Status: = Enabled
Querying: = Disabled
Proxying: = Disabled
Spoofing: = Disabled
Zapping: = Disabled
Querier Forwarding: = Disabled
Version: = 1
Robustness: = 2
Query Interval (seconds): = 125
Query Response Interval (milliseconds): = 10000
Last Member Query Interval(milliseconds): = 1000
Unsolicited Report Interval (seconds) = 1,
Router Timeout (seconds): = 90
Source Timeout (seconds): = 30
-> show ipv6 multicast neighbor
Total 1 Neighbors
Host Address VLAN Port Static Count Life
-------------------------+-----+-----+-------+------+-----
fe80::2a0:ccff:fed3:2853 5 1/5 no 1 6
-> show ipv6 multicast querier
Total 1 Queriers
Host Address VLAN Port Static Count Life
-------------------------+-----+-----+-------+------+-----
fe80::2a0:ccff:fed3:2854 5 1/2 no 1 6
To Next Page
Loading...
