EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6860 Series

Alcatel-Lucent OmniSwitch 6860 Series
1078 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 Index-3
dynamic log
LDAP accounting servers 31-24
E
errors 36-4
Ethernet
defaults 1-2, 1-3
flood rate 1-6, 1-7
frame size 1-5
full duplex 1-4
half duplex 1-4
Ethernet OAM
application example 37-8, 38-3
configuration 37-9, 38-4
Connectivity Fault Management
Continuity Check Messages 37-5
Link Trace Messages 37-5
Loop-back Messages 37-5
defaults 14-2, 37-2, 38-2
overview 37-3
verification 14-16, 37-14
ethoam association ccm-interval command 37-10
ethoam association command 37-8
ethoam association mhf command 37-10, 37-11, 37-12
ethoam association-default command 37-10
ethoam domain command 14-4, 37-8
ethoam end-point command 37-8
ethoam intermediate-point command 37-8
ethoam linktrace command 37-12
ethoam loopback command 37-12
F
Fast Spanning Tree 6-5
filtering lists
see ACLs
flow command 1-7
G
Guest Tunneling
topology example 28-90
H
health interval command 34-38, 37-12
health threshold command 34-36
health threshold limits
displaying 34-37
high availability VLANs 5-1
adding egress ports 5-7, 5-8
adding ingress ports 5-7
application examples 5-3
configuration steps 5-6
creating high availability VLANs 5-6
defaults 5-2
deleting egress ports 5-7
deleting high availability VLANs 5-7
displaying 5-16
traffic flow 5-5
I
ICMP 15-32
control 15-34
QoS policies for 26-78
statistics 15-34
icmp messages command 15-34
icmp type command 15-33
IGMP
multicast ACLs 26-63, 26-66
IGMP Spoofing 25-22
interfaces admin command 1-4
interfaces alias command 1-5
interfaces autoneg command 1-3
interfaces crossover command 1-3
interfaces duplex command 1-4
interfaces flood multicast command 1-6
interfaces max frame command 1-5
interfaces no l2 statistics command 1-4
interfaces speed command 1-3
Internet Control Message Protocol
see ICMP
IP 15-1, 16-1
application examples 15-3, 16-3
ARP 15-13
defaults 15-3
directed broadcast 15-26
ICMP 15-32
ping 15-34
protocols 15-4, 16-11
router ID 15-19
router port 15-7
router primary address 15-19
static route 15-11, 17-18
tracing an IP route 15-35
TTL value 15-20
tunneling 15-37
UDP 15-36
verify information about 15-39, 16-18
ip access-list address command 19-15
ip access-list command 19-15
ip default-ttl command 15-20
ip directed-broadcast command 15-26
ip dos scan close-port-penalty command 15-29
ip dos scan decay command 15-30
ip dos scan tcp open-port-penalty command 15-29
ip dos scan threshold command 15-30
ip dos scan udp open-port-penalty command 15-29
ip dos trap command 15-30
ip helper address command 21-8
ip helper boot-up command 21-11
ip helper forward delay command 21-9
ip helper maximum hops command 21-10
ip helper per-vlan command 21-10
ip helper standard command 21-10
ip interface command 19-3

Table of Contents

Related product manuals