Index
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 Index-2
bridge priority command 6-28
Bridge Protocol Data Units
contents 6-7
bridge slot/port command 6-31
bridge slot/port connection command 6-40
bridge slot/port priority command 6-36
built-in port groups
used with Policy Based Routing 26-79
C
clear arp filter command 15-16
clear arp-cache command 15-15
condition groups
for ACLs 26-53
MAC groups 26-57
network groups 26-54
port groups 26-58
sample configuration 26-53
service groups 26-56
verify information about 26-59
conditions
combined with actions 26-31, 26-32
configuring 26-44
how to create 26-44
see also condition groups
valid combinations 26-30
Configuring 802.1AB
application examples 13-3
D
debug messages 36-4
debug qos command 26-38
default route
IP 15-12
defaults
10/100/1000 ports 1-3
802.1AB 13-2
authentication servers 31-2
DHCP Relay 21-2
dynamic link aggregation 9-2, 10-2
Ethernet OAM 14-2, 37-2, 38-2
Ethernet ports 1-2, 1-3
high availability VLANs 5-2
IP 15-3
IPMS 25-2, 25-3
IPv6 17-2
Learned Port Security 33-2
Multiple Spanning Tree 6-4
OSPF 18-2, 20-2
policy servers 27-2
Port Mapping 32-2
port mirroring 34-3
port monitoring 34-4, 34-5
QoS 26-33
RIP 19-2
RMON 34-7
RRSTP 6-5
Server Load Balancing 24-2
source learning 3-2
Spanning Tree Bridge 6-3, 11-2
Spanning Tree Port 6-3
static link aggregation 8-2
switch health 34-8
switch logging 36-2
UDLD 2-2
VLANs 4-2
VRRP 23-2
Denial of Service
see DoS
DHCP 21-5
DHCP Relay 21-1, 21-9
application examples 21-3, 21-6, 21-7
AVLAN forwarding option 21-10
defaults 21-2
DHCP server IP address 21-8
forward delay time 21-9
maximum number of hops 21-10
standard forwarding option 21-10
directed broadcast 15-26
DoS 15-26
enabling traps 15-30
setting decay value 15-30
setting penalty values 15-29
Setting Port Scan Penalty Value 15-30
DVMRP 25-6
dynamic link aggregation 9-1, 10-1
application examples 9-3, 9-25
defaults 9-2, 10-2
group actor administrative key 9-13
group actor system ID 9-14
group actor system priority 9-13
group administrative state 9-12
group partner administrative key 9-14
group partner system ID 9-15
group partner system priority 9-15
groups 9-8
assigning ports 9-9
creating groups 9-8
deleting groups 9-9
group names 9-12
removing ports 9-10
LACPDU bit settings 9-16, 9-20
LACPDU frames 9-16, 9-20
Link Aggregation Control Protocol (LACP) 9-5
MAC address 9-14, 9-15, 9-17, 9-22
port actor administrative priority 9-18
port actor port priority 9-19
port actor system administrative states 9-16
port actor system ID 9-17
port partner administrative key 9-21
port partner administrative priority 9-23
port partner administrative state 9-20
port partner administrative system ID 9-22
port partner administrative system priority 9-22
port partner port administrative status 9-23
ports 9-9
verify information about 9-28, 10-12
To Next Page
Loading...
