26 of 220 Instrument Installation - Anatel A643a
RPS - June 2007 - Edition 12
Operator Manual Anatel
5) Press the Up and Down Keys to step through the alphabet (upper- then lowercase),
followed by a blank space and numeric values (0–9) until the desired character is
displayed.
6) Press Enter to save the new character and advance the cursor to the next position.
7) Again scroll through the display using the Up and Down Keys until the desired
character is displayed.
8) Press Enter to save the altered character.
9) Repeat the procedure until the desired Sensor Name has been entered into the
display, then press Enter twice to exit this function and return to the normal display.
It is possible for more than one Analyzer to have the same Name. Duplicate Sensor Names
may cause confusion when reviewing printed reports.
2.3 Hardware Installation
Once the Anatel A643a hardware components have been checked and initial software
parameters setup, the Analyzer can be installed. Installation consists of:
• Mounting the components.
• Providing the required plumbing, communications and power connections.
2.3.1 Mounting
The C80 Controller and the Anatel A643a–S Analyzer are the only system components that
require stationary mounting. The Anatel A643a–P Analyzer is designed to stand vertically on
its feet, allowing these portable instruments to move to different locations easily and perform
spot analyses. They must, however, be oriented properly.
Channel 1 Name
SE XXXXX
Esc selects char
S/T selects char
Fig 2-15 : Change Character
Channel 1 Name
SENSOR NAME
Esc selects char
S/T selects char
Fig 2-16 : Sensor Name Change
To Next Page
Loading...
Need help?
General
