ANATEL A643a User Manual

Anatel A643a - Anatel A643a Setup 55 of 220
RPS - June 2007 - Edition 12
Anatel Operator Manual
3) Press Enter to access its submenu.
4) Specify Display/Print from among the available selections and press Enter to display
its options.
5) Specify Set Password and press Enter.
6) Use the Up and Down Keys to specify Supervisor ID and press Enter to display that
screen.
7) Press Enter again and the flashing block cursor becomes a flashing underscore.
8) Use the Up and Down Keys to specify the initial character in the identification. An
identification is five alphanumeric characters and case-sensitive.
9) Press Enter to advance to the next character and similarly select it.
10) Repeat the selection procedure to define the other characters.
11) With the desired Identifier displayed, press Esc to return to the Set Password screen.
Note:
Be sure to record the Identifier and Password somewhere in case it is forgotten.
12) Use the Up and Down Keys to select Supervisor PW and press Enter to display that
screen.
13) Press Enter and the flashing block cursor again becomes a flashing underscore.
Fig 5-5 : Setting Supervisor Password Screen
1 SENSOR NAME
Supervisor:
Identifier:
Super
Fig 5-6 : Enter Supervisor ID
1 SENSOR NAME
Supervisor:
Password:
0
0000
Fig 5-7 : Enter Supervisor Password

ANATEL A643a Specifications

General

Brand	ANATEL
Model	A643a
Category	Measuring Instruments
Language	English