Anatel A643a - Manual Overview 7 of 220
RPS - June 2007 - Edition 12
Anatel Operator Manual
Manual Overview
About This Manual
The information in this manual has been carefully checked and is believed to be accurate.
However, Hach Ultra assumes no responsibility for any inaccuracies that may be contained in
this manual. In no event will Hach Ultra be liable for direct, indirect, special, incidental, or
consequential damages resulting from any defect or omission in this manual, even if advised of
the possibility of such damages. In the interest of continued product development, Hach Ultra
reserves the right to make improvements in this manual and the products it describes at any
time, without notice or obligation.
Published in the United States of America
Hach Ultra P/N: FG5704001 Edition 12, June 2007
Copyright © 1998-2007 by Hach Ultra Analytics, Inc.
All rights reserved. No part of the contents of this manual may be reproduced or transmitted in
any form or by any means without the written permission of Hach Ultra.
Safety Conventions
A warning is used to indicate a condition which, if not met, could cause serious personal injury
and/or death. Do not move beyond a warning until all conditions have been met.
A caution is used to indicate a condition which, if not met, could cause damage to the
equipment. Do not move beyond a caution until all conditions have been met.
A note is used to indicate important information or instructions that should be considered
before operating the equipment.
General Safety Considerations
• Read the Anatel A643a TOC Analyzer Operator Manual thoroughly before installing or
operating the instrument. Although the A643a is designed for rugged use, it is still an
instrument that should be cared for and maintained as described in this manual.
Following proper safety and handling instructions will promote accident free operation
and prolong product life.
• For any questions regarding the Anatel A643a, contact Hach Ultra at 800-866-7889 or
+1-541-472-6500.
• All service procedures should be conducted by properly trained service personnel.
• Make sure the A643a TOC Analyzer is properly installed and all connections are
correctly installed before operation. All safety guidelines should be observed.
• Follow all procedures in “Return Procedures” on page 189 before shipping a unit to a
service center for repair or re-calibration.
To Next Page
Loading...