ANATEL A643a - Page 9

Anatel A643a - Manual Overview 9 of 220
RPS - June 2007 - Edition 12
Anatel Operator Manual
This instrument has been tested and found to be in conformity with the following EU Directive:
• EMC Directive 89/336/EEC Low Voltage Directive 73/23/EEC
This instrument is in conformity with the relevant sections of the following EC Technical
Standards and other normative documents:
• Safety: EN 61010-1:1993 + A2:1995
• EMC: EN 61326:1998
EN 55011:1999
EN 61000-3-2:1995 + A14:2000
EN 61000-3-3:1997
EN 61000-4-2:2001
EN 61000-4-3:2001
EN 61000-4-4:2001
EN 61000-4-5:2001
EN 61000-4-6:2001
EN 61000-4-11:2001
Note:
The CE Marking applies only to 230 VAC instruments and has been affixed on the devices
according to the EU Directives noted above.
The A643a TOC Analyzer complies with those parts of 21 CFR, Part 11 concerning the
collection, retention, access and retrieval of data as electronic records. The instrument uses no
electronic signature(s), thus those parts of the rule referring to electronic signature(s) are not
applicable. Extensively documented and verifiable tests have been conducted to establish
21 CFR, Part 11 compliance.
The A643a TOC Analyzer System is comprised of a line of precision instruments which meet
or exceed the following international requirements and standards of compliance:
EN61010–1
Electrical Equipment for Laboratory Use,
Part 1: General Requirements
CAN/CSA–C22.2 No. 1010.1–92
Safety Requirements for Electrical Equipment for Measurement, Control and
Laboratory Use, Part 1: General Requirements
Customer satisfaction through continuous quality improvements.
In addition, the following international symbols are found on the instruments and throughout
the A643a TOC Analyzer Operator Manual:
High Voltage
Reference Document: ISO 3864, No. B.3.6
Standby
Reference Document: IEC 417–5009