Chapter 5: Sorting 173
6 Double-click the Test Sort button to deposit a drop at the Home location.
7 Inspect the collection device to see where the drop was deposited.
If you need to move the stage to the front, close the Device Setup dialog
box and click the Access Stage control in the Sort Layout window.
8 Wipe the collection device dry and place it back on the tray support.
If needed, click the Access Stage control to send the stage back and select
Sort > Home Position to access the Device Setup dialog again.
9 Adjust the Home location, if necessary.
Click the appropriate Arrow buttons to move the tray support as needed.
Large arrows move the tray by five steps. Small arrows move the tray by one
step.
10 Repeat steps 6 through 9 until the drop is centered appropriately.
11 Click Set Home, then Close.
12 Click the Voltage control ( ) to turn off the deflection plates.
13 Proceed with Sorting on page 164.
To Next Page
Loading...
