Bernina 790 - Using Cord with the Buttonhole Foot No. 3 C (Optional Accessory)

Buttonholes
125
> Pull the cord ends into the slits.
> Lower the buttonhole foot.
> Sew the buttonhole in the usual manner.
> Pull the cord through the buttonhole until the loop disappears in the bartack.
> Pull the ends of the cord through to the wrong side of the fabric (using a hand stitching-needle), knot or
secure with stitches.
Using cord with the Buttonhole foot No. 3C (optional accessory)
Prerequisite:
• The Buttonhole foot No. 3C (optional accessory) is attached and raised.
> Insert the needle at the beginning of the buttonhole.
> Hook the cord over the pin at the back of the buttonhole foot.
> Pull both cords ends under the buttonhole foot to the back and place each a cord into a groove of the
sole.
035964.50.04_2014-08_Manual_B790_EN