Bernina 790 - Programming the Button Securing; Programming the Foot Control

Setup-Program
56
> Touch the icon «Programming buttons and icons».
> Touch the icon «Programming the button Quick reverse».
> Touch the icon «Backstepping» to activate the backstepping.
> Touch the icon «Quick reverse permanent» to activate the permanent reverse sewing.
Programming the button «Securing»
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Programming buttons and icons».
> Touch the icon «Programming the button Securing».
> Touch the icon «Changing the number of securing stitches».
> Touch the icons «-» and «+» to enter the number of the sequenced securing stitches.
> Touch the yellow-framed icon to reset the alteration to basic setting.
> Touch the icon «Securing stitches in place» to program 4 securing stitches in place.
Programming the foot control
> Touch the icon «Setup Program».
> Touch the icon «Sewing settings».
> Touch the icon «Programming the foot control».
– The icon «Needle up/down» is activated.
– The back kick on the foot control raises or lowers the needle.
035964.50.04_2014-08_Manual_B790_EN