Bernina 790 - Changing the Upper Thread in the Embroidery Mode; Changing the Bobbin Thread in Embroidery Mode; Sewing with Connected Embroidery Module

Embroidery
153
Changing the upper thread in the embroidery mode
Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Touch the icon «Moving the embroidery hoop to the left».
> Thread the upper thread (see page 44).
> Push the button «Start/Stop» to move the embroidery hoop back to the last position.
Changing the bobbin thread in Embroidery mode
To facilitate changing the bobbin, it is recommended to move the hoop to the back before threading. This
makes it easier to open the bobbin cover.
> Touch the icon «Hoop display/Hoop selection».
> Touch the icon «Moving the hoop to the back».
> Thread the bobbin thread (see page 49).
> Push the button «Start/Stop» to move the hoop back to its previous position.
Sewing with connected embroidery module
The embroidery module can be positioned so that any sewing projects can be carried out even if the module
is connected.
> Touch the icon «Hoop display/Hoop selection».
> Remove the hoop.
> Touch the icon «Moving the module for sewing mode».
> Touch the icon «Home».
> Touch the icon «Sewing mode».
P
P
P
035964.50.04_2014-08_Manual_B790_EN