Preparation
42
Needle stop up/down (permanent)
> Touch the icon «Needle stop up/down (permanent)» to fix the needle position permanently.
– The machine stops with needle position down as soon as the foot control is released or the button
«Start/Stop» has been pressed.
> Touch the icon «Needle stop up/down (permanent)» again.
– The machine stops with needle position up as soon as the foot control is released or the button
«Start/Stop» has been pressed.
Changing the needle
> Raise the needle.
> Switch the machine off and disconnect it from the power supply system.
> Remove the presser foot.
> Loosen the needle clamp screw using the screwdriver grey Torx.
> Pull the needle down.
> Hold the new needle with the flat side to the back.
> Insert the needle as far as it will go.
> Tighten the needle clamp using the screwdriver grey Torx.
Selecting the needle
After having changed the needle, it can be checked whether or not it can be used in combination with the
selected stitch plate.
> Touch the icon «Needle selection».
> Select the inserted needle.
Selecting the needle type and the needle size
Convenient memory function: To prevent a loss of information, the needle type and the needle size can be
saved additionally on the machine. The saved needle type and the saved needle size can be checked at any
time.
035964.50.04_2014-08_Manual_B790_EN
To Next Page
Loading...
